Proflor is a two part floor leveling system composed of a blended cement powder base and a synthetic rubber latex emulsion. When mixed and applied as recommended Proflor results in a floor topping having superior adhesion, strength and density.

USES

Proflor has been formulated as a premium system for levelling and repairing concrete floors, creating falls or ramps, covering old adhesive or paints in readiness for carpet, vinyl or tile laying. Proflor may be used over wooden floors however movement in the timber may cause cracking of the floor topping. Excellent water resistance is obtained and rising damp problems alleviated on concrete floors.

TECHNICAL DATA

Type	Two part trowellable mortar.
Colour	Grey (concrete) when dry.
Colour of emulsion	White when wet - Clear when dry.
Density	Approx. 2kg per litre when mixed.
Shelf life	6 months in unopened bags - must be kept dry. Emulsion 12 months in unopened containers.
Flash point	Non-flammable
Coverage	As a guide a 25kg bag mixed with 5 litres of emulsion will cover approx 3 sq. metre at 6mm thickness
Pot life	Approx. 1 hour at 20°C.
Drying time	Varies depending on thickness and temperature. DO NOT sand for at least 24 hours at normal temperature.
Chemical resistance	Fair resistance to alkalis. oils and most household chemicals.

INSTRUCTIONS FOR USE

SURFACE PREPARATION
Substrate surface should be clean and free of grease or other contaminants which may affect a good bond. Dust should be removed by vacuum. Any deep cracks should be cleaned out and filled. For maximum adhesion of the topping, a primer coat should be applied. consisting of 1 part Proflor Emulsion; 1 part Proflor Powder by volume. Mix the emulsion and powder into a liquid slurry . Apply to the substrate surface at the rate of 250ml per 1 sq. metre on smooth concrete, up to 400ml on rough concrete.

APPLICATION
Pour the mixed compound onto the tacky priming coat and screed to the desired thickness. Trowel to give a smooth finish. Depths of over 6 mm should be obtained by applying two or more coats. Subsequent coats must be applied within 4 hours of the previous. otherwise priming is necessary. Small hollows up to 25mm deep may be filled with one coat although an increase in setting time will occur. Only sufficient material for one hour at 20 deg C should be mixed at one time.
Wash all equipment with clean water immediately after use. Foot traffic should be possible after 24hrs although floor coverings may be installed when dry, normally 3-7 days. In hot weather plastic sheeting should be used to prevent rapid drying out.

PACKAGING

Proflor is packed in - 25 kg bags - 40 bags per pallet.

The above information is based on our best knowledge and we beleive it to be true and accurate, however, due to the variable nature of application the suitability of the product for the use intended is the sole resposnibility of the user.

e-mail us about this product

The Spec Sheet PDF documents require the Adobe Viewer to be installed.
If you are experiencing problems viewing or downloading the PDFs, please click the icon on the right to ensure you have the latest Adobe Reader installed ... or email us, specifying the documents you require and we will send them to you by return email.